A solvent-free trowellable epoxy floor coating designed for floors to give a smooth tile-like finish without joints which are subjected to heavy mechanical wear and extreme chemical spillage.
Suitable for the protection and decoration of interior concrete floors
Non-Pollutant- contains no solvent
Smooth tile-like finish
Epoxy / Polyamide
: 9 standard colors, other colors per request
: SF-00 White SF-21 Classic Blue SF-40 Canary Yellow
: SF-10 Rustic Red SF-30 Mint Green SF-61 Velvet Gray
: SF-20 Misty Blue SF-31 Tropical Green SF-90 Sand Beige
Density, K/L @ 28°C,:
1.58 ± 0.03 K/L
Gloss @ 60°:
90 ~ 100
1 mm thickness 4 m2/4L, 2 mm thickness 2 m² /4L, 3mm thickness 1.33 m² /4L
Drying Time @ 28°C:
Light foot traffic after 24 hours. Full hardness after 7 days.
4 liter can set
One year when stored in dry cool conditions, out of direct sunlight.
Apply by trowel or squeegee
Stir both components well before mixing. Add catalyst to base and mix slowly but thoroughly for 10- 15 minutes. It is better to transfer contents to a bigger container for easy and homogeneous mixing.
3 parts base to 1 part catalyst by volume
Pot Life @ 280C:
1 - 1 ½ hours
Thinning / Cleaning:
Use Davies 95 Epoxy Reducer for cleaning only. DO NOT ADD REDUCER to Suprafloor mixture
1 Seal with one coat of Davies Eposeal-Epoxy Penetrating Sealer by brush or roller and let dry for 5-24 hours
Option 1 Plain Finish without aggregates. Proceed to Step 2 & 3.
Option 2 Non-Skid Finish- Broadcast anti skid additive on still wet Eposeal at 1 kilo/m²
and let it dry overnight When dry, dust-off excess additives. Then proceed to step 3.
Option 3 Plain Finish with Aggregates - Adding aggregates on the Suprafloor mixture at
ratio of 3:1:1 by volume (Base : Hardener : Aggregates). Apply by trowel or squeegee.
While still wet, finish off with a spiked roller to remove air bubbles and level-off at the
2 When necessary, putty hollow surfaces with Davies Epopatch - Epoxy Patching Compound. Mix Ratio (Base :Hardener) 1:1 by volume
3 Finish with one coat of Davies Suprafloor by trowel or squeegee. While still wet, finish off with a spiked roller to remove air bubbles and level-off at the same time. Let dry overnight.
1 Apply one coat of Davies Epoxy Primer by brush or roller and let it dry.
2 Finish with one coat of Davies Suprafloor by trowel or squeegee. While still wet, finish off with a spiked roller to remove air bubbles and level-off at the same time. Let dry overnight.